The Lucid Subaru RS2.5 grounding kit.

Thank you for purchasing this Subaru impreza kit. here are the directions to install the kit on your car.

www.paranoidfabrications.com

The wires are zipped tie together in the order they are to be installed. Starting with the one labeled “Passenger strut tower”

 

1. Start with the wire that has the larger of the two end ring terminals, and attach it to the strut tower or any bolt in that area.

2. The next one is attached to a 12mm bolt on the front intake .

3. Next attach to the 12mm bolt near the coil packs

 

 4. Attach the next ring terminal to the throttle body top bolt, 12mm

5. The fifth attachment point in on the drivers side intake, 10mm

 

 6. Now attach the last ring terminal to the NEGATIVE side of the battery
   

Once you have everything attached use the provided zip ties to attach the wire out of the way. Make sure to route it away from any high heat areas.

The above pictures are of a customers install. your wire routing may be different.

 
   
I am not responsible for any incorrect installation. item is sold as is, and no guarantees.  
Install kit at own risk, although there is no risk if installed properly.  
   

Kit may or may not look like the above kit, but it will attached in the same locations.

 

Thanks